This course presents you the concept and command required configuring Cisco routers in multiprotocol internetworks. Through lectures, discussions, exercises, and laboratory projects, you gain hads-on experience configuring fully operational Cisco routers. You will learn to apply Cisco IOS software commands to start-up and configure a newly installed router.

Course Objectives

This course will enable you to :

• Basic knowledge of data networking and seven layers of OSI & the OSI model and the functions and network devices associated with each layer.
• Local area network (LAN), network topologies including Ethernet, Token Ring , Fiber Distributed Data Inteface (FDDI), and the protocols used with them .
• Ethernet, Carrier Sense Multiple Access/Collision Detection (CSMA/CD), repeaters/hubs, bridges, and Spanning Tree Protocol.
• Install, configure & maintain Cisco Switching Technologies.
• Configure Cisco routers for operation in multiprotocol internetworks.
• Configure Cisco routers on WAN (X.25, Frame-relay, ISDN, PPP, HDLC).

Who Should Attend ?

• Network administrators and technicians who configure and support multiprotocol internetworks, and Engineers who are getting started with basic Cisco IOS software.

Pre-requisites

To attend this course you must have :

• Basic knowledge of data networking & TCP/IP calculation or equivalent

Course Outline

• Introduction to Internetworking
• High Performance for Solution for Desktop Connectivity (HPSDC)
• Value and network services
• Wide-Area Networking
• Introduction to Cisco Router Configuration (ICRC)